The KF4JVI Solar Powered Repeater
Photos and Descriptions of the
Thermal Belt ARC, Polk County, NC

For those that are interested in additional information of Solar Equipment
Please check out this link www.homepower.com.
This site will assist you in selection of your equipment and setup.

Please note that all of the pictures are at least 70K
and range all the way up to 300K in size.

The larger pictures of the controller panel shows very
fine detail of the components installed.

Our Repeater is located at Tryon, NC on the NC / SC State Line.
Tryon, NC may be found on the map between
Spartanburg SC and Asheville NC just west of Interstate I-26.

This is a local area coverage repeater covering Polk County, NC
and the Upper Area of Spartanburg and Greenville, SC.


KV4AL Robin Michael
Repeater Custodian

KF4RVQ Dan Moranz
Solar Power

There is additional text for each picture on the full size
print access by clicking on the thumb.

solar.gif (13979 bytes)

Our Solar Panels Array using 4 panels
to produce approx. 12 amps DC at 12 Volts under full sun.

outside05.gif (17965 bytes) outside06.gif (16679 bytes)

This is showing the wiring and the junction box.
Proper grounding of the equipment allows it to live through electrical storms

outside03.gif (14107 bytes) outside04.gif (12217 bytes)

Description of Our Solar Panels Array

Four Semiens M55 Solar Panels connected in Parallel.
Each Panel Produces 55 watts of 12 volt electricity at 3.5 amperage.
Connected in Parallel, the four panels produce a maximum
electrical charging output of 12 volts at 14 amps.

If on an average of only four hours of direct sunlight per day,
this will give us approximately 56 amp hours of battery charge daily.


Solar Controller

All of the pictures below are 200K or larger to provide very fine detail.

Ananda Power Technologies Solar Controller.

The solar controller automatically regulates the charge to the battery bank.
This provides an automatic float charging or disconnect of the
Solar panels when the battery bank reaches full charging capacity.
The Controller Box also provides the circuit breakers to isolate the
Radio, Batteries, and solar panels.

Below is the controller panel for the battery pack

pannel06.gif (15857 bytes) pannel07.gif (13446 bytes)
pannel08.gif (12531 bytes) pannel09.gif (12854 bytes)

Photo below is the fusing for the battery pack.
Below that is a sub controller for aux power if necessary

pannel10.gif (13214 bytes)

The Battery Bank

The Battery Bank consist of four Deka Gel Packs
12 volt at 220 amp hour per battery.

Connected in parallel, this provides 880 amp hours
of electrical storage at 12 volts.

This storage capacity will power the KF4JVI radio repeater for approximately
8 days with out any additional charging form the solar panels.

batterypack01.gif (13395 bytes) batterypack02.gif (14016 bytes)

 


 

ant1.gif (6490 bytes) ant3.gif (8143 bytes) ant2.gif (9825 bytes)

Our Antenna mounted atop a 35 foot telephone pole.
Our antenna is made by Cellways Inc.

outside01.gif (13741 bytes) outside02.gif (10452 bytes)

Work crew in the lower left photo above


repeater06.gif (14628 bytes)

Overall View of the Repeater Station.

repeater01.gif (13858 bytes) repeater04.gif (13787 bytes)
repeater02.gif (13887 bytes) repeater05.gif (13553 bytes)

The Actual Layout of the equipment of this repeater site.

The equipment sits atop of the duplexer which is housed
in the lower part of the cabinate.

rep-equip.gif (8876 bytes) rep-equip2.gif (8608 bytes)

The KF4JVI Repeater equipment consist of the following equipment:
Yaseu - Vertex 2 meter DC only power repeater
S-Com V7 Repeater Controller
2 pair duplexers ~ 2 tx and 2 rx
4 batteries at 220 amp hours sealed gel packs.
Solar Controller assembly
Overkill on lightning protection
Green Box is Backup / standby power if necessary - so far not required.

repeater06.gif (14628 bytes)

The Complete Solar Powered Repeater Station.


Hit Counter